How to install the aquabliss HS300 TheraSpa hand shower
All aquabliss products are designed for self-installation — no specialist skills or tools are needed. The full installation takes around 5 minutes and follows the same basic steps as any standard shower head change.
Prefer to follow along with a video? Watch the full installation demonstration
Step 1 — Remove the old shower head
Grip your existing shower head at the connecting nut and turn it counter-clockwise until it comes free. If it's stiff — often caused by mineral buildup or old plumber's tape on the threads — take a look at our How to Remove an Existing Shower Head guide for tips on loosening it safely.
Step 2 — Clean the shower arm threads
Once the old head is off, wipe down the exposed end of the shower arm with a dry cloth to clear away any residue, mineral deposits, or old plumber's tape. For heavier buildup, fine steel wool will clear the threads without damaging them. Clean threads are important — they give the new fittings a solid surface to seal against and help prevent leaks from the outset.
Step 3 — Install the shower mount
Take the shower mount (the bracket that holds the handheld shower head) and twist it onto the shower arm where your old shower head was, turning clockwise. The mount has two connection points: one screws onto the shower arm pipe from the wall, and the other is where the shower hose attaches. Hand-tighten until firm.
Step 4 — Attach the hose
Take one end of the shower hose and twist the connector clockwise onto the shower mount connection. Take the other end and twist it clockwise onto the inlet connection of the shower head. Both connections should be hand-tight — avoid over-tightening, which can damage the threads. Once connected, hang the shower head in the bracket on the mount.
Step 5 — Adjust the angle
The shower mount swivels, so you can set the angle of the holder to suit your height and preference. Dock the shower head in the bracket and pull gently to tilt it to the angle you want. You can also rotate the whole mount sideways if needed. Once set, the bracket holds its position during normal use.
If you run into any difficulty during installation, contact us directly — we're happy to walk you through it.