Fixed Shower heads

How to Install the TurboSpa

How to install the AquaBliss TurboSpa shower head Watch our how-to video here Remove Existing Shower Head Remove the existing shower head by turning it counter-clockwise. Use a wrench if necessary. Clean Shower Arm Clean any excess material from the shower arm threads. Wrap plumbers tape around the threads 2-3 times. Install New Shower Head Attach the AquaBliss TurboSpa shower head to shower arm and hand tighten it clockwise.

Adjusting the Angle of the TurboSpa

Change Shower Head Angle Watch our how-to video here The shower head has a pivot ball which allows you to adjust the angle of the shower head. To do so, firmly grasp the from of the shower head and gently pivot it left, right, up or down to your desired position.

Cleaning the TurboSpa

Cleaning the showerhead Gently wipe with a damp cloth and dry with a soft towel. Do not use harsh, abrasive cleaning products or polish. Cleaning the water jets The TurboSpa shower head has rub-clean water jets. To clean them, gently move the water jet side to side with your finger or use a soft cloth. If you have a lot of scale buildup, you can rub the water jets while the water is running. This will dislodge any buildup.

Leak between TurboSpa and Shower Arm

Leakage between the shower and the shower arm can occur if the washer is not seated properly. Remove the shower and check the washer inside the connection nut if it is STRAIGHT and FLAT. Gently use a screwdriver or pen to push the edges of the washer down. Re-attach the shower to the shower arm. If the leak persists, use a screwdriver to remove the washer from the connection nut, flip it over, and set it back in. If the washer doesn’t stop the leak, use plumber’s tape on the shower arm.